RFID modulis RC522 13.56MHz

7.00

RFID module RC522, 13.56MHz reader/writer, NFC
RFID-RC522

Noliktavā 12 prece/-es

Apraksts

RFID-RC522 karšu lasīšanas-rakstīšanas modulis 13.56MHz
Strāvas stiprums darbojoties: 13-26mA/DC 3.3V
Strāvas stiprums gaidot: 10-13mA/DC 3.3V
Strāvas stiprums miega režīmā: <80uA
Maksimālais trāvas stiprums: <30mA
Raidīšanas frekvence: 13.56MHz
Atbalstītie karšu tipi: Mifare1 S50, Mifare1 S70, Mirafe Ultralight, Mifare Pro, Mirafe DesFire
Izmērs: 40mm x 60mm
Darba temperatuūra: -20 – 80 C
Glabāšanas temperature: -40 – 85 C
Relatīvais mitrums: 5% – 95%
Komunikācijas interfeiss: SPI
Datu pārraides ātrums: max 10Mbit/s
Lasīšanas attālums: 5cm

RFID-RC522 module 13.56MHz reader writer
Operating current: 13-26mA/DC 3.3V
Idle current: 10-13mA/DC 3.3V
Sleep current: <80uA
Peak current: <30mA
Operating Frequency: 13.56MHz
Supported card types: mifare1 S50, mifare1 S70 MIFARE Ultralight, mifare Pro, MIFARE DESFire
Size: 40mm x 60mm
Operating temperature: -20 – 80 degrees Celsius
Storage Temperature: -40 – 85 degrees Celsius
Relative humidity: 5% -95%
Module interface: SPI
Data transfer rate: maximum 10Mbit/s
Read Range: 5cm

Pin Configuration
1 Vcc – Used to Power the module, typically 3.3V is used
2 RST – Reset pin – used to reset or power down the module
3 Ground – Connected to Ground of system
4 IRQ – Interrupt pin – used to wake up the module when a device comes into range
5 MISO/SCL/Tx – MISO pin when used for SPI communication, acts as SCL for I2c and Tx for UART.
6 MOSI – Master out slave in pin for SPI communication
7 SCK – Serial Clock pin – used to provide clock source
8 SS/SDA/Rx – Acts as Serial input (SS) for SPI communication, SDA for IIC and Rx during UART